A crash program to produce the PPD 34/38 after the initial battles of the Winter War, even as the improved PPD 40 was being rapidly developed. These are very rare gun today, and we have the chance to take the example out to the range and see how it handles…
Semiauto Rifles
VSS Vintorez: Russia’s Silent Sniper Rifle
The VSS (Special Sniper Rifle) Vintorez was one of two dedicated silenced rifles developed in Russia in the 1980s. The Vintorez was given a very good barrel and intended for precision shooting, while the AS […]
Competition
Backlog of Video!
While I have been posting daily videos from the recent series of Rock Island Auction material, I have also been publishing the occasional video on InRange TV – and some of those would probably be […]
Aircraft MGs
Vintage Saturday: Salvage
Finnish troops salvaging Maxim guns from a downed Russian Polikarpov R5 bomber shot down near Suistamo, Finland.
How to get hold of them? Good question. PPSh-41 is not much different; holding it in front of trigger guard is not a good proposition either – it does not provide enough leverage. https://www.youtube.com/watch?v=_06eehCXhYw
Perhaps that is why you see them being held by magazine. But then you run a chance of malfunction. Same applied for assault rifles.
“(…)why you see them being held by magazine(…)”
Regarding PPD (with original box magazine) this is what user manual http://militarylib.com/ww2/ww2-weapon-book/13458-nastavlenie-po-strelkovomu-delu-ppd-pistolet-pulemet-degtyareva-obr-1934-g.html does want, see drawing 55
thank you. so, according to the original user manual, they simply held the gun by box magazine, or two finger in the front grip and 3 fingers on the box magazine. curious.
I bet it handled a lot better with the original 25 round box magazine. Any pictures of that magazine?
Odds are the Red Army would have been much better off just producing the original form of the SMG with the box magazine, and emphasizing semi-auto fire vs full-auto. Stalin’s interference and insistence favoring drums looks very counterproductive in hindsight.
“(…)pictures of that magazine?”
See left half or 2nd image photos from bottom https://www.kalashnikov.ru/rozhdenie-ppd/
haha, according to your page there was a pneumatic tool to slow the rate of fire! it was in the place for the main spring. never heard about that. thanks
Remove stock. Cut two inches off fore-end. Refit stock. Look officer in the eye and say “Struck by bullet. Field-expedient repair, Comrade Commissar”. Operate holding barrel-shroud.
“(…) Operate holding barrel-shroud.”
If you want to do this consider using KF-42 see 1st image from bottom
https://www.jaegerplatoon.net/MACHINEPISTOLS1.htm
During Continuation War a small number Suomi submachine gun M/31 copies in 7.62 mm x 25 calibre were manufactured in Leningrad. The Soviets called this unlicensed copy KF-42 (Karelo-Finskij 42).
It did incorporated elements from SUOMI and PPD (among others shroud of latter)
How to clean a weapon which cannot be disassembled?
Solvent tank.
…makes sense. When a tank went over a weapon (and its sleeping owner) during my service in a Warsaw Pact army, there was indeed no need to clean the affected AKM-47. Issue ‘solved’.
At least one pre-Warsaw Pact Soviet manual I’ve looked at has this to say about “cleaning” the PPSh41–Shpagin: Remove magazine. Pull bolt back until the sear engages and the bolt is locked to the rear. Pour a little kerosene into the ejection port. Use a rag or a hank of tow or hemp to wipe off the bolt face, chamber area. Pull the trigger. Work the bolt handle back and forth a few times. Done.