Enter your email address to receive notifications of new posts by email.

US Bommarito rifle

The Bommarito was one of the prototype self-loading rifles presented to the US Ordnance Department during the early 1900s. It was chambered for the standard .30-06 cartridge, fed from 20-round detachable box magazines, and was invented by a man named Giuseppe Bommarito. On April 5th, 1918 the War Department allocated $2500 for its development, followed by an additional $2000 on September 28th, 1918. The investment didn’t produce a useful result, as the results of extensive testing were “unfavorable”. Its principle operating problem, apparently, was a habit of failures to extract, with a subsequent problem of the action very difficult to open manually with a stuck case in the chamber. The design was tinkered with by Major Elder (who also worked with the Rychiger rifle), but without any ultimate success.

Bommarito rifle right side

Bommarito rifle right side (click to enlarge)

Bommarito rifle left side, action open

Bommarito rifle left side, action open (click to enlarge)

The design used a short-recoil toggle lock similar to the Luger, with a recoil distance of 1.25 inches. This is a bit unusual – much longer than most short recoil designs, but not long enough to be a long-recoil system (which requires the locked recoil distance to be equal to or greater than the length of the cartridge). Because of this long recoil distance of the barrel and the size of the toggle lock arms, it was found to be a very awkward weapon to use, and liable to injure shooters’ fingers during handling.

Thanks to Miles Vining, we have a few new photos of the Bommarito tested by the Ordnance Department:

 

Bommarito rifle fully disassembled

Bommarito rifle fully disassembled (courtesy of the US National Archives via Miles Vining). Click to enlarge.

Bommarito rifle major components

Bommarito rifle major components (courtesy of the US National Archives via Miles Vining). Click to enlarge.

Bommarito rifle toggle

Bommarito rifle toggle (photo from Springfield Armory National Historic Site archives). Click to enlarge.

These photos make it clear how the rifle actually worked. Note how the front sight is mounted on what is actually just a barrel sleeve locked into the stock. The barrel itself travels inside that sleeve, which probably would have had adverse consequences for accuracy had the rifle progressed far enough for accuracy to be a consideration. The small diameter coil spring connects the moving barrel to the front barrel sleeve (note the small hook at the rear of the sleeve), providing the force to pull the barrel forward after each shot. This sleeve also allows the rifle to retain the look of a fixed-barrel weapon, since the moving barrel and extension are hidden under the handguard. In theory, that should also aid reliability by shielding the mechanism from ingress of dirt.

The toggle lock uses the ball at one end as a pivot point. It is set in a socket in the receiver, while its lugs lock into the square cuts in the barrel extension. The ball remains in its socket as the barrel and barrel extension move backward, which forces the toggle joint to break, and after enough travel the locking lugs disengage and the barrel is pulled forward by its return spring while toggle continues to open, to eject the empty cartridge case.

Unlike the Luger pistol and Pedersen rifle, the Bommarito version of the toggle lock appears to be relatively simple to manufacture. That is something of an accomplishment, but it doesn’t really help if the finished product isn’t practical to use…

6 comments to US Bommarito rifle

Leave a Reply

  

  

  

You can use these HTML tags

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>