Harald Sunngård was Norwegian inventor in the early years of the 20th century who noticed a common perceived weakness of automatic pistols: reloads under stress were often bungled by shooters, leaving them vulnerable to return fire without being able to shoot back. Doing the classic inventor thing, Sunngård figured out a solution to the problem – a two-part solution, in fact. The first part of his solution was to use a big magazine and a small cartridge, to maximize magazine capacity. The second part of his solution was to store a spare magazine right in the magazine well of the pistol for immediate use.

Sunngard automatic pistol, 6.5mm
Sunngard automatic pistol, 6.5mm

The grip of the pistol is long enough front-to-back to store two identical magazines. The front magazine sits higher than the rear one, and the boltface on the slide feeds rounds from the front magazine into the chamber. Once the front magazine is empty, the shooter ejects it, and need only slide the rear magazine into the front position (and rack the slide) to continue shooting. There is a misconception that the pistol will fire automatically from both magazines in succession, but this is not true.

In addition to having the handy spare available, Sunngard designed the magazines to hold no fewer than 25 cartridges each (in the more common 6.5mm chambering). This gave the pistol a total of 50 rounds stored on-board, which was a major point in Sunngard’s marketing.

The 6.5mm cartridge designed for the pistol had a 23mm overall length, and used a 19mm case. The projectile was a scant 28.5 grains (1.85 gram), and Sunngard claimed a muzzle velocity of just under 2000 ft/s (600 m/s) – which is almost certainly an exaggeration. There was also an 8mm version of the pistol made in much smaller numbers, which fired an equally light projectile (29gr / 1.88g), and may have gotten closer to the claimed velocity (magazines for the 8mm version held 18 rounds each).

Sunngard pistol patent drawing
Sunngard pistol patent drawing
8mm Sunngard pistol
8mm Sunngard pistol (in Koblenz museum; photo from Norsk Vapenhistorisk Selskap Nr. 143)

The process for moving the spare magazine into position is fairly well described in the patent (attached below). The main magazine catch is basically a heel release on the front edge of the magazine well, and it is pushed back in the typical manner to allow the primary magazine to be removed. Then the rear magazine is pulled slightly forward and down as if to remove it from the gun. The rear magazine is then slid forward into the front position and pushed back up to lock into place on the magazine catch. A pair of small guides (labelled “6” in the patent drawing above) at the top of the magazine well prevent the magazine from being pushed backwards into the now-empty space for the spare magazine, and these guides are the reason the spare mag must be pulled down and then pushed back up. When initially loading the pistol, the spare magazine is inserted first, and locked back into its compartment (held up by a fixed shelf, “9”). Then the primary magazine is inserted just like in any other pistol.

Sunngard apparently tried hard to market the pistol to a variety of military forces, but found no takers. He was able to get the gun entered into the 1914 Norwegian military trials, where it was bested by the Colt 1911 (we don’t have a testing report from the trials, which would be very interesting to read). If I had to guess based on the general attitudes of the day, I would suspect that Ordnance officers found the reloading process awkward, the cartridge underpowered, and the need for a very high capacity pistol unconvincing.

Mechanically, the Sunngard is pretty simple. It uses a plain blowback action, as no locking system is necessary for its small cartridge. The barrel is fixed to the receiver, and a recoil spring is located around the barrel and inside the barrel shroud/slide.

Technical Specs

Caliber: 6.5mm (also 8mm)
Cartridge: 6.5mm Sunngard (6.5x19mm) (also 8x19mm)
Bullet weight: 28.5 gr (1.85g)
Overall length: 8.0in (203mm)
Barrel length: 6.2in (158mm)
Height: 5.3in (135mm)
Weight unloaded: 26.8oz (760g) (28oz/800g for the 8mm variant)
Weight loaded: 33.8oz (960g)

Patents

US Patent 972,087 (Harald Sunngard, “Automatic Firearm”, October 4, 1910)

4 Comments

  1. I actually agree with the top comment, actually. If it had a long barrel, a fore grip, fully/semi auto, and had a stock. This gun would make a pretty decent small caliber carbine / rifle.

  2. Too bad this gun is not on full auto.. plus the ammo is under powered. Any request for a 38 super conversion and a barrel extension plus stock addition for the Sunngard (don’t worry it will be just a replica).

Leave a Reply to OmniT00 (Name on Steam, too!) Cancel reply

Your email address will not be published.


*